Because this is an internal program in the system.)ġ8 N sequence number is from N0001~N9999 (optional. Programs between O9000-O9999 cannot be specified. I believe everyone will use it.)ġ6 PAGE Page up and down (For screen content exceeding 1 page, this key is effective.)ġ7 O program number is from O0001~O9999 (FANUC 21i-T has special instructions. Press start When the button is pressed for processing, the machine will alarm.)ġ5 CURSOR Move the cursor up and down (just like the up, down, left, and right keys of our computer keyboard. In PROG mode, press this key, the program cursor will return to the first display of the program TOP. Very convenient.)ġ3 DGONS PARAM display self-diagnosis and parameter functionġ4 RESET Return to stop (this key is for processing after modifying a section of the program. There are absolute and relative positions, which can be switched and displayed. This key is required for the end of each program.)ĥ CAN cancel (used in the case of EDIT or MDI MODE)Ħ INPUT input program and code is used more when inputting a new program.ħ OUTPUT START output program and instructionsĨ OFFSET Store tool length and radius compensation valueġ1 ALARM Display the alarm content or codeġ2 POS display coordinates (After pressing this key, CRT will display the current position of each axis of the machine tool. Enter N1 and press this key.)Ĥ EOB completion sentence (END OF BLOCK) (This key is the meaning of ' '. For example, program 'G01X30.0Y50.0F0.08 ' to insert 'G99' before 'X30.0', first move the cursor to 'G01', Then enter 'G99' and press this key again.)ģ DELET Delete program (To delete an address. Program input: program switch on O→program number→INPUTĭo not check overtravel: press EOB＋CAN to turn onġ ALTER modify the program and code (input a section of address, such as X20.0 and then press this key, the address at the cursor position will be replaced by X20.0.)Ģ INSRT Insert program (move the cursor to the front of the address to be inserted. Program full input: program switch on O→-9999→INPUT Program delete: edit mode O→program number→DELET

Program output: edit mode O→program number→STARTĭelete all programs: edit mode O→-9999→DELET Program full output: edit mode O→-9999→START Program clearing: parameter switch ON, press DEL＋RST to turn on Parameter setting initial value: parameter switch ON, press RST to turn on Operation list (KND100M system CNC milling machine)Īll memory is cleared: parameter switch ON press RST＋DEL＋STR Any function key +CAN to turn off the display

Cnccom fanuc program